Separate names with a comma.
I've run either Bryant or Velasco billet TF cranks in our A/fuel dragster, and would like to know who has run Winberg, and if there were pro /...
Looking to buy: 1) Current style BAE std deck block, prefer: 1" lifter bores / 4.375 bore / 54 mm cam tunnel; can have .904 lifter / 60mm /4.4167...
Anyone out there know of a good deal on Lucas 60W race oil (the newer red/wine colored blend)? Need a barrel or two, one for Gainesville for sure....
Lookin to buy a 1:56 to 1:6 gearset for a Lenco CS2 Thanks, Clif cb@nitrobull.ca
I use the 11-bolt Vernier 48T cam drive gear, and the center pc, that bolts to the cam w/ 3 of 3/8 bolts (& positioned by the two dowel pins of...
I presently have a BAE block, Bruno converter drive, & lenco 3 spd The Bruno has a cast aluminum bellhousing, between the Bruno converter drive &...
I have to replace the center housing on my TD, re-using my Strange 9.5 pumpkin. I have the spindles/hubs/etc, and can make the spindle bells to...
I use Morel lifters on our A/Fueller, 1" bore w/ a .920 roller dia, and as these are TF lifters, they have the dbl exh roller set-up (one roller...
DragRaceCentral sucks....anyone out there got a connection at D4 so someone can post the racing results from OK? Can't be that hard...post it...
Have a Top Dragster that we will back half this winter, and want to replace the old fabricated rear end housing & spindle / brake assembly with...
As the title says, looking to get a spare centre section for my A/Fueller. Chrisman 10.5" w/ 290 gear set. new or used cb@nitrobull.ca...
Just switched to psi spline on our A/Fuel motor, just looking for a recommended torque on the 3/4-16 bolt, seeing as it's 4.5" long, not 2" like...
Congratulations to Megan Meyer & Kris Hool, who won TAD & TAFC at the Four-Wide Nat'ls ! Both teams were consistent in running good numbers, and...
I know this has been up in the past, but the threads are old. Who makes a good 0-15 gauge? My CSR is out a bit, CSR doesn't offer them anymore,...
For a good number of years we could view the ESPN coverage of national events about a week after the event, courtesy of Kman on YouTube. Now they...
8 Used BAE 5 Fatheads for sale, reason: changed combination. 4 heads fresh from BAE, 4 have 6 runs since fresh. Will sell bare, bare w/ studs, or...
We presently use Manley lash caps, .130 deep w/ an .080 thick 'cap', for an overall length of .210", for our 11/32" Manley valves. Trying a new...
Near new Mark Williams 11" Modular diff, with the built-in pinion oiling pump. Has only 11 runs on center section, gears, axles & brake...
Who out there makes the best dual mag drive support, the one that bolts to the 3 block studs & supports the mag drive underneath, and typically...
Looking for a near-new bae std deck block, 4.375 bore / raised cam / spread bore / 1" lifter bore /2.125 cam tunnel Clif cb@nitrobull.ca
