Separate names with a comma.
The reason I mention it is obviously coil bind. If you can set up your heads for a 2.100" installed height then you have a way bigger selection of...
Keep an eye on installed height also, you don't mention what lift your cam is. Corey
Perfect,thanks for the responses :) Corey
I'm guessing by the responses that this isn't going to really hurt much if the oil is warm. Corey
Thanks, that's how we do it anyways (50/50 gas/meth). Big thing is will firing the engine in the cold ambient be an issue?
This is aimed more at my fellow Canadians but anybody can give me an opinion. I finally got my engine fired this last weekend and have to do a few...
40% leak? Is that because its a screw? Corey
The only times I have had flames out the headers was when my plugs were going away, it was igniting the fuel outside the head and in the header....
What type of ignition are you running? When I had a marginal mag SMIII I would kill a set of plugs in 1-2 passes. First pass would be strong, next...
I'll take a shot at this as no one has yet. My rods came with L-19's from GRP. They said stretch the first few bolts properly, then if you want to...
I just went through all this using a paintball rig to fill race bottles. You need to make or buy a small fiber washer to seal against the face of...
OK, but how can it not effect the higher RPM because the poppet will still be open? As the rpm goes up so will the pressure, the poppet couldn't...
Unless the highspeed is an electric solenoid isn't it going to stay open past the pre-set crack point? It won't work at low pressure and not at...
I think I know where you are going with this. I am going to have the same problem. How much butterfly opening do you need to do a good burnout?...
I think the M5 had a lot to do with that.;)
I looked at those as well, those don't flow as well as the ones from RFD. Corey
This is the only new design billet I'm aware of. http://www.raceflowdevelopment.com/RFD-heads-BBC-BILLET.htm If these don't get you there,...
How fast are you looking to go, as far a conventional heads you pretty much have the best already. RFD has some Edelbrock HIP casting...
There used to be a place called Western Wrist Pin that would make you any pin you wanted. I got a few sets from them, they seemed fine. I don't...
First of all I'm no expert at all on this but I believe a #8 vent is fine for a # 12 inlet. I use a #10 on a 1 1/4" inlet and it passes the "glug"...
