Separate names with a comma.
Wondering the weight of a 4.467 bore fathead piston. What compression height is popular with this piston?, just curious. TIA Scott
So, I am working on the diet and was wondering about the front motor plate, I see the dragsters and funny cars with a much smaller motor...
Working on the winter rebuild and fine tuning for next. The 7730 has a "Time/RPM" brown and white wire that currently activates a leanout relay...
Ok guys and gals, This might be an interesting thread...... How much more timing is needed if the "Blue Line" is 1/3 to 1/2 down the ground...
Currently running two batteries in the jalopy. Power Grid and all of car's electronics supplied with 12 volts. I have a second battery in the...
I am changing gears this winter. My nine inch housing is iron with Lenco cast into it. The gears are 4.29 "10" inch and in perfect condition....
Ran this season and last with MT "Bubba" 3190 tire, looking to replace them this winter. Opinions on either tire? 2800 (class rules) door car,...
I have an MSD 44 mag and several of the standard caps and rotors. I also have several wider MSD rotor tips that I can put onto these caps. The 44...
I was thinking one day in the jet..... "Would there be an advantage to adding timing as RPM increases?" Sometimes I have a little too much...
Hi again, Went out for the outlaw race tonight, made two attempts at going down the track to further work on my tune and had issues. 526...
Looking into all sorts of weight loss ideas, any pros or cons to using titanium bolts to replace the 1/2 lower front control arm bolts and 3/8...
I have a 24 and a 25, is there a 23?? TIA
Hi again everyone, Now that we are making it down the track in one piece, I am starting to look at optimizing rear gearing for 1/8 and 1/4...
Finally Some Good News (and a question about blower belt life) We went to the track yesterday, things went well. 26 degrees of timing all in at...
Comparing the 11mm and 8mm PS belts on a screw, does the 11mm reduce HP output due to parasitic losses? If so, any ideas on how much? TIA
After all the repairs to the heads, block and stuff after my latest blow-up (self induced, owned it), I am assembling the motor and checking...
Guys and gals, I am looking for to buy a junk (or borrow) spare Brad 5, 6, &, 8 or NRE head and stands/rockers to mock up on my TFX 1.8 lifter...
What kind of airflow/power difference would I see between these two heads? 4.310 bore 4.5 stroke on both? Thanks guys and gals
Cherry set of Brooks 88 Connecting rods for a Hemi. 7.126 length, 1.094 pin, 2.375 (2.5) rod. They have been assembled in an engine, turned out to...
Ok guys, first I would like to say thanks for the help and advice already given. I have been hot rodding for years, but my learning curve has been...
