Separate names with a comma.
hi all! would anybody have boost numbers from a whipple R 980 at low overdrive? getting started with that blower and wanting to creep up on the...
hi all! are taylor thundervolt 8.2 wires ok on a hemi blown alcohol application using a supermag 5 magneto and whipple screw blower? what are you...
hi all! my engine builder is having the following issue: on my old brad fuel heads,i installed new stage five rocker arms and new shafts. pushrods...
Hi all! i have this problem with the o-rings on my old BAE fuel heads: they were equipped with .050 wire that was damaged so we decided to change...
Hi all! What spark plugs would be ok to start with on a whipple screw blown KB hemi with BAE fuel heads,FIE SM 5 magneto, in a door car,running...
hi all! sorry for asking what might seem to most of you obvious,but i'd rather ask before spending my hard earned cash: do lencodrives and bruno...
Hi all,this is Cyril again... what are those using a bruno drive doing regarding cooling? Here in France,one door car racer has a radiator on his...
Hi all! i am about to have a repaired KB stage 6 hemi block machined (bores opened from 4.310 to 4.375) since my last thread about sleeves moving...
Hi all! first,let me apologize in advance if this is a dumb question: is it possible to use a wet sump oil pump(KB billet,16AN inlet from oil...
Hi all! would anybody using a whipple screw blower tell me what snout bearing(and seal) they are using,and where to buy one? i thank you in...
Hi all! took my KB stage six block to the machine shop this morning and he found the four center sleeves to be out of round,the bigger mesuring at...
hi all again besides my engine sleeve concern(apparently solved) in my KB hemi engine,i was wondering if there were parts that needed to be...
hi all i ve had this solid block,standard deck hemi KB engine for some time now that i bought used. now has come the time to put it in my car and...
hi all again!! switching from blown alky KB wedge motor with wet sump oiling system(RCD pump) to hemi dry sump (still RCD pump)and i'm scratching...
Hi all! working on a KB mag intake and removed burst panel frame and "adapter" made by the previous owner (see pics) it happens that the panel...
Hi All! could anybody using this lenco specific item tell me about how it works(cable operated?),if cable brackets need to be welded to the...
Hi all! Is there a "basic" front end setup To work from on a Blown alky promod chassis? I ve been using my chassis "as bought" so far and even...
Hi all! in a blown alcohol door car application,what is considered to be the minimum speed applied to the driveshaft for balancing? i had one...
hi All! i'm about to buy a hand held weather station:what is best to get started? door car with blown alky KB wedge thank you in advance for...
hi all would any of you have the instruction sheet for this weather station? a friend of mine(in France)has a brand new one,never used,but he lost...
