Separate names with a comma.
What about a Lenco button type shift valve operating a small air cylinder connected to an Enderle style 2 way shut-off with a check and pill tee'd...
Bob, Try to mount the solenoid valve as close as practicable to the cylinder. Gases are compressive so you need to reduce the volume in the lines....
Thanks Greg.
Hi Bob I made my launch control ~20 years ago by mounting a Bimba air cylinder to the hat with an adjustable stop. The barrel linkage would push...
I adapted a regular MSD one from a SBC.
Really depends whether the sleeves are a tight interference fit in the block or not. Most are made to be replaced easily at the track without...
It's only a presumption, could be any number of reasons. Where does the returning cooler circuit fluid go in a Lencodrive, in most OEM's it's used...
Whilst the converter is multiplying torque the stator is stationary and the fluid flow through the stator channels is not too messed up. As the...
I'm not familiar with the Lencodrive hydraulic layout but it sounds good in theory. I'm assuming that you taking hot fluid from the pan and then...
It's preferable to measure the pressure on the inwards flow port because if there's any internal flow restrictions in the converter then the...
Converter charge PSI x converter drive tube's square inches area = pounds force on the engine's thrust bearing ....... "unless" you are suffering...
Yeah, it's all totally different now but there's always more than one way to skin a cat.
NA Hilborn 40+ years ago usually had a ~3 psi idle bypass check and a ~20 psi secondary check that would close off at ~30% open throttle onwards...
Absolutely.
LH front is 1/2" out and the RH rear is 1/2" out ..... doesn't that now make it a parallelogram".
I'm lost now too. Try to do the rear end squareness check by doing my earlier measurement method ..... it may need the engine out though. If the...
It could be someone's attempt to help balance the chassis torque reaction by moving the center of gravity off to left 1/4". Also check if the...
Don't rush into chopping it yet. Measure from the width C/L of the chassis/wheels at or near the front axle to each rear spindle hubs and see if...
Hi Bob, Just to compare with carbs, a Bug Catcher has ~32 square inches of butterfly area, that equates to a 1 x 4 bbl all with 3-3/16" diameter...
You could mount a P&P/RCD hemi style dry sump pump off the front using an RCD adapter. Still able to remove it easily for priming oil pressure....
