Separate names with a comma.
This is the way business is supposed to be done. When you buy one of Randy's products mount it all up the way the instructions tell you to, cut...
If the block has been repaired in the mains make sure the rear cap is flush with the pan rails. Sometimes they don't machine the cap enough andit...
I have used the RPM Performance unit since 2000. Great service, very tuff, upgradeable, very reasonable priced.
Kevin Most use Les davenport you can buy it direct, for around $800
The best way is to wash them in a washing maching. Chain the lines together and put them in the machine one at a time. I use purple stuff to break...
I understand the converter cars have a problem getting the RPM's up and that needs to be addressed. I am a NO. to many wires and hoses now. Wayne
David You might try your local Hoosier tire dealer, but if they can't help you call me. I will talk you through this. The stem for the...
Are the manifold studs out of the heads? If not remove them and see if it will sit down. I have one block that was .100 tall that I cut down to...
call Chase at Crane cams 18663885120
I have used the RPM performance from Randy since 1998. I have had 3 units sold the other 2 with cars. Quality and service, best unit out there....
Gear ratios If you multiply the ratios together it will give you the trans (ie. low gear ratio) 1.47 x 1.39= 2.043 . If you shift either section...
oil pres. Are you wanting to reduce oil pres. on a hot or cold engine? There are shims behind the by pass spring take the plug out ( #6) add or...
cheap oil You are right it gets harder every year to field a car. The best way for our team to save money is with the oil. Anyone that has been...
I have an older gear drive that has an idler that is attached to the spindle with a snap ring. The spindle also sticks through the front cover....
Bv Do you run a radiater in this car? When you look at the BV turn it to the left to lean it or right to richen it. I normally make a mark on...
they are 4s
You need to check this in high gear (shifted) It helps if the front seal is out of the trans.
Thanks I bought a new set from Robert , he had them in stock. Thanks again, Wayne Butler
send it back to KB or Tfx they roll or extrude the threads in aluminum blocks
I am looking for a phone number for Stage 5 thanks Wayne3608@grics.net
