Separate names with a comma.
Building cpl of my old TFX 92 motor for Nostaliga and bracket racing. Going to be turrning 9000 max.Will run some nitro in nostalgia stuff but...
Looking at enderle twin gear pump and would like input from anyone with experience with them. Biggest concern is any cavitation issues.
Bednar1320 take it to 18% and let us know if it makes another 2.5 to 3 lbs.Would be interesting to see how far it goes and stays linear...
180 to 200 has always worked for us.Mr Ralph Gorr told me where cam should be and it should read at least 180# but less than 210#.This is with...
Have dsr on injected hemi.IMO tons better than 80A. Not enough run time to say how well it holds up.
Well had one repy.But did not work out. Must be too many tunner out there.LOL
Never ran anything else on brlower motor.Never had a issue.I did not think anyone ran anything else.LOL
If not too late I could use new one.1st choice silver,but black will work.Wydopn2312@yahoo.com
1/8 mile burnout is huge fun meter number,low fun for guy paying for it. I was both and learned fun is not worth cost. Have always done roll and...
As stated get those gears out of it. Not only are they killing any chance of getting out of hole,top end rpm will be ungodly . In our old funny...
I always go by plugs and use egt as back. Slow read is another issue. Owner was talked into computech datamax instead of racepak,not by me either....
MSD 8973. Have read cpl articles about problems with earlier models and wondering if still exist with newer models/ Asking because helping TA/D...
Lots of info on net .Most is carb and no not same as with injection.Runner cross section, length and tapper do matter.Most A/fuel cars have...
WE used a spool that allowed us to bring the two systems in as stated above.* dribblers for idle and stage and secondary larger nozzles for full...
I ran 12.5:1 and also ran the 296-500 cams.Heck think I still have cpl of the cams and one is in a injected hemi right now. We found out that...
Ran both blowers same short block combo only thing I did was flip flop port nozzles to work with blower discharge point and added a little fuel...
If you have egt;s pull rod bearings for hottest cylinder or one for cylinder with bad plug.If you are hammering the bearing out then you know its...
IMO 2 pieces means 1 more than 1 piece to leak.
First rule of tuning.The motor will tell you waht it wants..If plugs,egt's and bearings tell you you need more fuel then give to it.Worst thing to...
Have box full of brass but neer ran them.Heck they are heavy.LOL
