Separate names with a comma.
Anyone kn ow who sells a 4 corner swap cam for Hemi with std journals? Have found some for larger journal but non for standard journal,
Found this out by accident. Right side bank will all be lower cranking compression.Motro will run like this and will be close but not optima. I...
Looking for team needing help. Have 3 years workiong on A/fuel cqar as clutch guy and half of tuning team. Have tons of experience working on...
how many ekg 9's do you have.
head gaskets what you have left? if a pair of .040 and pair of .080 I will take one pair of each. cmconstruction2312@gmail.com
Shaeffers oil in 70 wt. wondering if anyone is or has run it? I have 55 gal. drum and while can run especially if mixinf 30 and 70 will give me a...
with triggert sit mag fairly close to actual timing. We ran mag at 58 and our trigger max was 65 on A fuel as example. Then with grid set as want...
Should b e good combo. Can see it making 2500 if have enough load to make it burn most of the pump. On A fuel you run 25 to 28 gpme to motor. That...
HAve barrle of Shaeffers oil. Must be pretty good stuff. Just never ran iot and looking for thoughts from thoser who have. It is straight SAE 70...
If NA with alky you can leave compression or up it with thinner gaskets. Most A/fuel guys run 12.5 to 13.5 depending on air and combo. WIth alky...
Lots have found the lockup too abusive to bottom end.Lockup at wrong time and motor will pull the rods out. Like any tool the wrong use can be...
Most pros run something like grid where you set timing thru computer and use crank trigger. the mag just has to be set to a base and real timing...
Like most have had a issue of killing adjuster from time to time. Thinking about going nto all tool steel adjusters or at least on intakes....
I have built quite a few sets. If I can get the plates which should not be problem I can have you a set built same week as get them.( Chris...
I run a former TA/D blown engine now in NA trim. Runs fine/ I would think if an A/fuel motor the compression would have been up around 14:1. If...
Depends on cam. I allow about .010 growth. I normally run valves when engine is cool and go .008 to .012 if hot I will go .018 to .022. Never...
have always used exh. opening adjust intake intake closing adjust exh. After 30 years of doing so I just watch as motor is rotated and grab them...
I know with A/fuel cars #1 journal is standard crack location. Supposedly a swap cam will help. Changing firing order so as not to beat crank as...
when mag is already 12 less than trigger and you pull 12 to 15 at the hit and add in 5* thru box. Throw in a dead hole and it seems recipe for not...
To answer a question. When setting the distributor and crank trigger or phasing the two. How close to same should they be or better stated how far...
