Recent Activity

Michalek Brothers Racing posted a new thread.

Michalek Brothers Racing shop clean out sale

o Black braided nylon hose – new ($45 for everything)  -10 x 5-1/2’ = $15  -10 x 4’ = $10  -12 x 8-1/2’ = $30 o Hose...

Forum: Noonan Classifieds

ggracing replied to the thread BAE 452 Complete assembled short block.

4.50” crank with 4.375 is 540 cubic inches. 3.750 crank would be 451

Top Fuel Fredeosa posted a new thread.

BAE 452 Complete assembled short block

Complete assembled ready to run BAE short Block used in A Fuel Dragster Never windowed, 4.375x4.50 Velasco splined crank with CP rods...

Forum: Noonan Classifieds

Top Fuel Fredeosa posted a new thread.

BAE 452 Complete assembled short block

BAE short block fresh and ready to run, never windowed,used in A fuel dragster Short deck 4.375x4.50 Velasco splined crank with CP rods...

Forum: Pit Buzz

Mike Canter replied to the thread RCD Starter Solenoid.

It is not voltage that burns up solenoids it is high amp flow Every time the contacts open or close the high current flow arcs the...

Full Tilt posted a new thread.

dry sump hemi

is it normal to drain pan and put back in tank , there is still oil in tank but it is down a couple of quarts. will it equilize

Forum: InsideTopAlcohol.com Tech Questions

h2b puller replied to the thread RCD Starter Solenoid.

The new RCD solenoids don"t last long on 48 volts we put a resistor before the solenoid to lower the voltage to 24 volts. the older...

rb0804 replied to the thread launch timing retard method.

Depends on what you have and what your trying to accomplish. If you have a converter drive with a planetary type transmission behind it,...

Dirty Deeds replied to the thread RCD Starter Solenoid.

I've had two 48v solenoids fail on me. So I used a standard Ford 12v solenoid and ran a separate cable(cable tied to main cables) to one...

nitrowannabe replied to the thread Blower Re-Strip on my way to Benson NC/PDRA.

Looks like 77 goes thru Mooresville and Charlotte. Critchley ? Scott Gaddy ? I 77 is several hours from Galot. Galot is right off I 95.

nitrowannabe replied to the thread launch timing retard method.

Describe your car to the experts here. I probably need to know the answer also.

rickey posted a new thread.

launch timing retard method

I have ask 4 different people and got four different ways on timing retard at launch. does it really matter when you retard it? as soon...

Forum: InsideTopAlcohol.com Tech Questions

drew556 replied to the thread Brad Penn oil formula change?.

Extreme oil is the way to go won’t break down has a great additive package Alky won’t mix with it been running it for last two years in...

bandit496 replied to the thread RCD Starter Solenoid.

Was at the National Tractor Pulling Championships this weekend and know of 2 RCD starter solenoids that failed. These were new units....

Outlaw68 replied to the thread RCD Starter Solenoid.

I want one that runs 24v but is activated by 12 volt.