Separate names with a comma.
Thanks for the info.
Any difference or preference on running aluminum or brass nozzle bodies?
Am I correct that the drive is measured from the mounting surface of the front cover or rear of the drive mounting surface to the front flange...
Where do you measure a blower drive to determine it's actual length? I have a KB block with an 8-71. I have been told by a few people that the...
Anyone else needing information on this subject can reach Indy @ Telephone: 317-862-3724 Fax: 317-862-6300
Found out from Robert that only the Dart intake will work with these heads. There are two different bolt hole spacings available on Dart heads. My...
I have a Weiand aluminum 7150 blower intake I purchased some time ago and wanted to run it with my current heads. My heads are 16 bolt Dart/Total...
I have an Auto meter 6831 Monster Tach with an Auto meter 5306 pro control module that matches my Mallory Super Mag ll. Can anyone recommend a...
On Board Camera Not everyone can afford one? I think that should be left to the JR. dragster owners to decide. Video is a leading tool in...
