Separate names with a comma.
The studs you are looking for may be available from ARP.
You could probably have some adapter plates/spacers cut at a qualified fabrication shop but it may not be worth the effort and would be prone to...
Someone I know used a Dunn offset drive for a BBC motor years ago to clear the blower with his 44 mag. Might check out an offset distributor drive.
I have been running the 5671A-9. Stock #6596. Seems to be the same plug except that the hex size is 5/8 instead of 13/16. NGKwholesale.com $1.84
I have had the same experience with nitrous solenoids when I tried to use them as lean outs. They generally did not flow near as much as I...
I run a 14 HH with a delta at 42% OD and I see 38 PSI on a 526 alky hemi with big chamber fuel heads. Does not seem to be too hot on the air temp....
I agree. Does not seem like a real situation.
At this point, I am not sure how the magneto was removed... loaned or stolen or sold with a bad check or what?
Something else I do when putting heads on my hemi is to add an oring at the head bolt at the block that is the oil feed path to the rockers....
Around the return holes and the oil feed hole. My AJ fuel heads have about a 1/2" oil return hole. A push rod dimple would not be big enough for...
One would hope that the "racer" family would be an honest group. If they truly borrow something, it will be brought back quickly. A racer...
My Brad hemi also has a noticeable space between the heads and block. Personally, I would never use a totally dead soft gasket but that is just my...
Depends on which oil pan you have. I suggest taking the pan off, prop it up level and count how many quarts of water it will hold to the top of...
Might check the linkage to see if there is anything binding or over center and check the return springs.
May be too much cylinder clearance to wall and/or out of round bores.
