Separate names with a comma.
Modern racing pistons are drilled from the oil ring to the wrist pin bore. Makes a sort of pressurized pin oiling system. Works good too.
Use a N20 filter when transferring CO from a bulk source to the tank for your car. Filters liquid at extreme cold temperatures and keeps debris...
It is worth the expense of shipping your Crank to a well known reputable shop and usually cheaper than the gas to drive it somewhere. If you need...
Buy new parts in this area because it is MUCH less expensive.
I use a N2O filter when refilling the CO bottle. No junk in the system since. Why everyone is not doing this is a mystery to me.
Powder coating your wheels would increase the weight significantly. The heating process would most likely damage the seal between the two halves.
I personally use and sell Red Line Alcohol Fuel Lubricant part # 41102 12OZ bottle $11.95 Use 1oz per 5 gallons, one bottle treats up to 55...
I have used RainX for years. Put it on once a year and no problems. Most auto parts stores sell this stuff. www.rainx.com
I have a full set of Sealed Power Rod Bearings .010 that were .0015 too tight on a project we did. Put them in and torqued up the rods and stopped...
You are 100% right That was something I CUT AND PASTED from the site given credit for it. I should have read it all first. But it was late...
I put a small K+N air filter on the end of my vent tube. I also have a shut off valve in the vent tube. Just never forget to open it !
Goodridge is an excellent product line and has everything you could need. We use it. Goodridge is the brand Will sells at dragracehose.com
Just plumb the system so when you pop your chutes you do not release the air pressure to your shift pods thus causing the transmission to...