Separate names with a comma.
I don't know why it is used to rate the spring with a pressure while the spring creates a force. Then it should be rated with newton, kilos,...
Just a stupid question. You always talk about OD but I think the number to check should be the actual RPM of the blower. 16% OD on a 10k revving...
Don't trust too much on the EGTs, put more care to the spark plugs. For example if youre too much retarded the EGTs will rise a lot because of the...
I'm not for sure an expert, but I would think in terms of compression ratio and keep the clearances as a limit to stay safe. So you should measure...
Already broke some. You can order them one by one directly from AJPE for less than 200$ each I think. Remember that you need to machine them on...
Still available? If so, please send pics to roccopowerteam@gmail.com
Small bore is not an issue. The problem is the windows...I'd prefer to have it in good conditions. If you have, please send some pictures at...
Still searching!
Is it possible to convert it to std deck? We can machine the deck and the sleeve seats. The rest is the same?
Bump! Still searching for a block
Want to buy a TFX 2000 or 2002 engine block: - standard deck - standard mains - 2.125 cam size - cam bearings - 4.610 / 4.550 sleeves OD (tighter...
Thank you Mike. Don't know why many team send them for checking apparently without any problem.
You didn't mention the bridge that connects the 2 negative terminals in the coil but I believe you have it (ground of the point box/magneto to the...
Hi everyone, I'm running msd promag 44 point box with rev limiter. I know many teams send them to msd for testing. They don't exibit any...
