Separate names with a comma.
Hi..... I highly recommend contacting Spud Miller, the founder of FIE . He invented the device you are trying to hook up and is also the...
Fuel Injection Enterprises in Albany Oregon has purchased the Mallory magneto product line and is manufacturing new ones. They also have repair...
My setup is as follows: -Idler is 3.080 between flanges -Belt is 1360-8 mm 2.970 total width. My belt tends to move toward...
Flaming River FR 1001 $ 65.00 At Summit Runs on 2 D batteries. Has clamp on outside of wire feature for spark lead. ....
Give them a call Anthony 719-219-3107 719-201-7659
We use an on board Tilton super 12 volt starter powered by a Miersch 24 volt remote battery pack and charger. Our set up uses 10 foot...
Suction stainless braid lines can be sucked flat. The internal rubber hose collapses. The only way to test is under significant vacuum and that...
Hello Neil Please send my your e-mail address .... you are 19 hours ahead of us. rayhadford@frontier.com 425-238-3235
What happened to the performance in the ET & MPH area? During this lull in racing I have been watching YouTube stuff With Gale Banks. By the way...
Your boost number is a critical part of the problem. Peak boost capture kits are less than $ 150 . and could save you serious $$ in burned...
Please share the answer.... I switched from Redline to Lucas Extreme Duty Marine ATF pure synthetic meets type F and FA.. That was...
I was changing out my dated Manley aluminum rods and found cracked pistons described on this forum in another thread..... the pistons and rods...
Race Pak has a thermal couple with a 3/8 I.D. lug....... have mine bolted to the outside end of a cylinder head. You will need to add another V...
HI Ryan D ......... Is your bearing issue possibly Methanol corrosion? Does not look like a wear issue to me..... I have seen the same thing...
