Separate names with a comma.
some in the region of 3.9 to 4.3 should work
very important for bbc forever is put a slight chamfer on the mating edges of the bearing to get oil to the thrust faces
been running bbc b/e for years. advantage = yes less bearing speed and slightly wider rod - just buy a couple of sets of bearings
had this very same issue years ago when i tried GW 50 wt. my conclusion was also methanol contamination
rb0804 this makes sense, as this has only happened since switching out the aluminium stator for a steel one.
TB locks car solid - TB applied to shift the lever for forward / reverse. So no speed when this action took place. Band is perfect. With TB off...
Just to clarify -the transbrake has never slipped, the last 2 outings ( since grinding the drum and fitting a new band ) all of a sudden it now...
lucky devil: hemi, chance, psiD. b&j 3 speed mike. rpm I read the 160 pressue at was 2-2200. adjusted in and out appeared to not change. came up...
bruno brake clamps like no tomorrow. converter drives the car from the get go - very hard to hold it on the brakes. set up at idle with 160 psi...
80A is too small 110 and if using an original style enderle and tank is below pump and not using a priming pump - then get a spur gear pump, in...
ali heads or steel. if ali what type. some aftermarket heads have cruddy guide material that s/s valves dont like. take oil restricters out if...
you could try caster oil. i use it in my fuel as a lubricant, it leaves a thin film in the base of the tank
you have caught my attention. i run a blown fed. 1st time ever ive had a tank below the pump. (990 enderle) I fitted a cheap 25.00 methanol...
with line off from pump to bv put this line to a container that you can screw the inlet line onto a fitting - to avoid any danger. fire engine on...
