Recent Content by Nitrofish4700

  1. Nitrofish4700
    Post

    Oh chute...more questions!

    he was also testing a new kevlar parachute
    Post by: Nitrofish4700, Jul 22, 2008 in forum: Pit Buzz
  2. Nitrofish4700
    Post

    Header Flanges/ Weld up kit

    thanks for the info i found a source for both now the only thing is what is the easiest way to put the round tubes on a square port ?
    Post by: Nitrofish4700, Jun 8, 2007 in forum: PSI Superchargers Tech Questions
  3. Nitrofish4700
    Thread

    Header Flanges/ Weld up kit

    Anyone know where to purchase hemi flanges for older dart fuel heads or a weld up kit for a f/c double wall
    Thread by: Nitrofish4700, Jun 7, 2007, 4 replies, in forum: PSI Superchargers Tech Questions
  4. Nitrofish4700
    Post

    Mag Shuttoff With 8973 Controller

    on our pro mag 12 with the 8973 we had problems breaking battery terminals all the battery powered was trans brake and 8973 when the battery went...
    Post by: Nitrofish4700, May 26, 2007 in forum: PSI Superchargers Tech Questions
  5. Nitrofish4700
    Post

    MSD 8973 lessons learned...

    we run ours staight off the mag msd recommends ion gear for the cable
    Post by: Nitrofish4700, Mar 22, 2007 in forum: PSI Superchargers Tech Questions
  6. Nitrofish4700
    Post

    NHRA Legal MSD Timing Control

    http://www.youtube.com/watch?v=dFVvZea3lGk This is one of our on board shots listen to the 2-step when we're up on the t-brake
    Post by: Nitrofish4700, Dec 13, 2006 in forum: PSI Superchargers Tech Questions
  7. Nitrofish4700
    Post

    NHRA Legal MSD Timing Control

    We have been using the 8973 on our blown alky FED and have had great success with it we leave a 3100 on the tranny-brake WO throttle a good...
    Post by: Nitrofish4700, Dec 8, 2006 in forum: PSI Superchargers Tech Questions
  8. Nitrofish4700
    Post

    PRI Show in Orlando

    will be there saturday
    Post by: Nitrofish4700, Dec 8, 2006 in forum: Pit Buzz
  9. Nitrofish4700
    Post

    BLOWN BBC setup

    We use a IV block unfilled 468 cid 10-71 20 over with about 12.0-1 compression we've been 6.74 @ 201 in a front motored car TroubleMaker...
    Post by: Nitrofish4700, Dec 4, 2006 in forum: PSI Superchargers Tech Questions