Recent Content by moparmark

  1. moparmark
    Post

    Fuzzy magnesium-dow 7 coated

    What's Kroil and where do you get it? Thanks, Mark.
    Post by: moparmark, Sep 19, 2009 in forum: PSI Superchargers Tech Questions
  2. moparmark
    Post

    Clearances for blown Mopar Wedge

    Thanks guys! I really appreciate this! What about the valve guide clearance with titanium intakes and exhaust?
    Post by: moparmark, Jul 24, 2009 in forum: PSI Superchargers Tech Questions
  3. moparmark
    Post

    Clearances for blown Mopar Wedge

    Thanks, I really appreciate the input. Mark.
    Post by: moparmark, Jul 24, 2009 in forum: PSI Superchargers Tech Questions
  4. moparmark
    Post

    Clearances for blown Mopar Wedge

    Thanks for the reply, Dave. The rods ARE B2's...my mistake. What about rods, mains and valve guides? Thanks again, Mark.
    Post by: moparmark, Jul 24, 2009 in forum: PSI Superchargers Tech Questions
  5. moparmark
    Thread

    Clearances for blown Mopar Wedge

    I could use a little help with some specs as this is going to be my first blower motor. My combination is as follows: KB stage 5 solid block,...
    Thread by: moparmark, Jul 23, 2009, 9 replies, in forum: PSI Superchargers Tech Questions
  6. moparmark
    Post

    Four-Link Altered?

    Four-Link Altered Thanks guys for all the feed-back! My original plan was to go with the hard tail, but all the "why nots" associated with the...
    Post by: moparmark, Nov 21, 2008 in forum: PSI Superchargers Tech Questions
  7. moparmark
    Post

    Four-Link Altered?

    Four-Link Altered Now we're getting somewhere! Thanks JT. That's what I was expecting to hear but It's good to have that confirmed. Thanks for...
    Post by: moparmark, Nov 19, 2008 in forum: PSI Superchargers Tech Questions