Separate names with a comma.
I have had the best luck with a Impact nitro helmet with the mask inside then the fresh air actually blows on the shield as you are breathing...
just have the block bored for the right size sleeve
most good shops can do this
when you bore the small sleeve out it, the cly wont stay round...
I am a big fan of Amsoil 0w-30 motor oil
since i switched to that many years ago
not trans issue since
this is in a cs-1
Insure it for a shit ton of money each way and they will bend over backwards to find it..
they lost a lenco of mine once and was extremely...
Can you have the manifold "o" ringed and do away with the gasket?
Call Kris @ ISP he can walk you thru it
its not that difficult
First thing i would do is take the pump off and send it to RCD and have them check it for flatness or binding
possible pin coming out of the...
i may be wrong but i think the 40 spline axles are all the same
everything thing else is not between mfgr's
Bout damn time Marty
Dennis looking at the pictures from Dave this happened after the ring gear about at the sun gear back not at the flange as it was still intact,...
I thought welding Ti was easy
in a sand blast cabinet
purge the box
weld away like mag or alum
easy as pie...
Or you have to wait 2 months to get a simple re-tag on a blower restraint
Yes Dennis I am still pissed
I have one of the electric yellow pumps in the trailer in case we had air problems i would be willing to sell if interested
The shims are .040" thick x 3.335" O.D. with a 2.375" I.D. and the bearing is .120" thick x 3.335" O.D. x with a 2.375" I.D