Separate names with a comma.
MGP has always had that in there instructions about removing torque if the rods are going to sit for any length of time. I've switched to R&R and...
Found one, bought a Janis with a CFH billet case. Having Janis go through it now and freshen it up. Hopefully turns out to be a good blower,...
I’m sure this is sold by now? Looking for a blower.
Looking for a top shelf roots blower for outlaw promod, no junk. Anything out there ?
My leak down procedure is the same with the -10 on the backside of the BV disconnected and cap the idle check. We are just a small family run...
Thanks Mike, yes it acts way fat . I keep chasing my tail on this thing as I keep being told it surges in gear because it’s lean but yet all signs...
Yes, I have the 750MJ box and FT had me set it up at 950MJ because the box will usually out put more on a good battery. Rage fuel systems had me...
Fuel tech FT spark ignition 30 degrees of timing, 1471 XR1 HH at 20% OD. Last season it made 38 lbs at the stripe at 20%. The changes we made in...
I have been struggling with idle surge in gear, and getting any kind of head temperature above 120. Even going as lean as .8 GPM at 1900-2100...
Yes, verified all port lines were dry.
It’s all brand new engine combo so hasn’t been down track yet.
I can keep #1 in the low 300's without leaning on the BV too much, flow meter at .9-1 gpm. #2 seems to be the biggest problem, it is low 200's...
Forgot to mention using a K style BV, blades set at .009.
