Separate names with a comma.
68 lbs. fuel pressure at 7500 rpm ?
BME , they are a forged rod, never had one fail in 15 years, I replace after 50 runs. Cheap insurance
Any shop with a spin balancer can do it, I trick the hood switch on ours, some you can put a magnet on, some your need to loosen and rotate the switch
hoosier liner and tube
comp cams severe duty with high pressure oiling
Yes I do, 69 camaro nostalgia funny
Jim sends it to DJ
Joe did not mess with my plate, must have been a rookie employee.
dj will recert the deist stuff they do my 14.2 restraint
On my BBC with J&E pistons they are gas ported right above the top ring in the upper ring land, parallel to the ring. Lower half of the hole is...
Billy's a good guy, knows his sh*t
All the rods get wallered out. this has been happening since assembled. Compression is lower in # 1 & 2, front holes are alot fatter because of...
piston to head clearance is good, thinking of getting rid of the buzzard, been running a K valve all along, has a Gerardot spool
426 forgings
straight pin, .220 thick not sure of clearance. 52100 high carbon steel, JE pins
