Separate names with a comma.
We have one and love it on our T&D rocker application.
I just PMed you the info.
I am actually an antigravity battery dealer. Their batteries are all Lithium and work awesome. A couple of 12 or 16 cell batteries should work...
It's a bit of a luxury, but if you have access to it Kephos coating by Keko Coatings is awesome. It can be a little more expensive then powder...
What's the general consensus on tickling a degree or two of timing back into the timing curve at higher RPM? This would be in a naturally...
Exactly, Do you agree (on an optimal track) that we should be pulling timing out of it as the RPMs pick back up after the car exits the corner?
In our USAC midgets (injected methanal 200inch pushrod 4cyl) the common practice is retard the base timing between 2 and 4 degrees as the motor...
Calico does most of the bearing coatings for the cup motor shops. They are good guys, they do a ton of OEM work as well. In our USAC midget...
In thinking about it, could the fuel leaking from the aerated hat nozzles on shut down be caused from air blowing by them and causing a syphon?...
Back in the day Waterman as well as a couple of other guys made a device called a "windshield saver" that went around Aerated nozzles that had...
It's awesome to hear Bob is back up and going after leaving BR, one of the best by far.
Do you see anything wrong with just grinding the tips off of them out of the box?
This is an Interesting topic. We have been doing a lot of midget racing and our particular motor package is relatively hard on the valve train...
Give BMRS wired a call. They are the wiring division of Brown and Miller Racing Solutions here in Concord. They do the wiring harnesses for...
