Recent Content by blwilliams

  1. blwilliams
    Post

    8 MM pulley VS 8 MM GT

    Robert thank you for the tip about inside diameter I'll check.
    Post by: blwilliams, Jun 22, 2018 in forum: PSI Superchargers Tech Questions
  2. blwilliams
    Thread

    8 MM pulley VS 8 MM GT

    I'm new to blower stuff so hope this is not too bad of a question. I have a TBS blower setup and I want to buy a smaller top pulley. Belt is a GT...
    Thread by: blwilliams, Jun 22, 2018, 1 replies, in forum: PSI Superchargers Tech Questions
  3. blwilliams
    Post

    industrial methanol and racing methanol

    Is there any other way to check for methanol purity other than specific gravity? What is an allowable range of the specific gravity from good to...
    Post by: blwilliams, Dec 8, 2014 in forum: PSI Superchargers Tech Questions
  4. blwilliams
    Post

    Need solid BBC head large port

    Thank you for the suggestions. Yes AJPE does make a beautiful billet head. Very expensive as well. We are looking into the best way to try and...
    Post by: blwilliams, Dec 12, 2011 in forum: PSI Superchargers Tech Questions
  5. blwilliams
    Thread

    Need solid BBC head large port

    What are people running for cylinder heads in high boost (44-45 psi) blown alcohol applications? We have been running the Dart 410 CC big M in a...
    Thread by: blwilliams, Dec 12, 2011, 5 replies, in forum: PSI Superchargers Tech Questions