Recent Content by blownapex

  1. blownapex
    Post

    GPM @ Idle

    what about 600-700 egt or 700-800 if you want it mean 70 od im about .6 gpm 92od im about .75 128 im about .85gpm but thats my c screw combo at...
    Post by: blownapex, Mar 19, 2022 in forum: PSI Superchargers Tech Questions
  2. blownapex
    Post

    command module no spark

    thanks ill work on that tomorrow night
    Post by: blownapex, Mar 9, 2022 in forum: PSI Superchargers Tech Questions
  3. blownapex
    Post

    command module no spark

    thanks i found it red activation wire didnt have power screw on msd relay module was screwed on to insulation not wire now we have new problems...
    Post by: blownapex, Mar 9, 2022 in forum: PSI Superchargers Tech Questions
  4. blownapex
    Thread

    command module no spark

    command module no spark mag and box have spark when plugged to mag pickup only does the sd card have to be installed it ran last week and now no...
    Thread by: blownapex, Mar 8, 2022, 4 replies, in forum: PSI Superchargers Tech Questions
  5. blownapex
    Post

    3sp. lencodrive

    1 1/4 input shaft???? hemi bell housing
    Post by: blownapex, Oct 18, 2020 in forum: Noonan Classifieds
  6. blownapex
    Thread

    afr how

    how is every body calculating or getting air fuel ratio screw blown promod hemi automatic race pack datalogger jetsize so once you get the plugs...
    Thread by: blownapex, Jun 20, 2020, 18 replies, in forum: PSI Superchargers Tech Questions
  7. blownapex
    Thread

    converter in /out dump pressures info

    i need help with a lenco drive dump or a turbo 400 would be a good comparison on pressures and rpm im a budget promod racer (midwest promod)...
    Thread by: blownapex, Dec 21, 2019, 1 replies, in forum: PSI Superchargers Tech Questions
  8. blownapex
    Post

    Crankcase Pressure Levels

    what does the pressure go to if you get a cyl at 90%leak down
    Post by: blownapex, Jun 8, 2019 in forum: PSI Superchargers Tech Questions
  9. blownapex
    Post

    CS2 clutch packs

    518 /46re
    Post by: blownapex, May 29, 2019 in forum: PSI Superchargers Tech Questions
  10. blownapex
    Thread

    can anyone weld magnesium

    i have a lenco drive that has been timeserted and several pulled out can any one out there weld this up and redrill these holes front plate bolt...
    Thread by: blownapex, Apr 21, 2019, 2 replies, in forum: PSI Superchargers Tech Questions
  11. blownapex
    Thread

    wtb lencodrive front main case

    wtb lencodrive front main case must be in very good condition no stripped holes thanks 618-781-4703
    Thread by: blownapex, Apr 21, 2019, 2 replies, in forum: Noonan Classifieds