Separate names with a comma.
Just wondering which method everyone uses when degreeing in a cam. I have always measured 050 both sides of peak lift and was happy with that but...
Hi Will What will you take for the clutch with the scalloped (solid) flywheel?? And thickness of discs and floaters please Russ
Does this clutch have the lightened flywheel ?? (scalloped out back?) Thanks Russ
I've been watching #5 take a beating on my hemi for a while now and figured it might be time to try a shorter rod... I figure it could really...
Hi Mike I have had the same experience as B. Doucet. There is no rpm curve - no launch curve - just a time curve. But I think the key is...
Yep, that's a good point ...I was nearly caught out on that one but why does it show a different base timing when it hasnt been triggered? And...
G'day Propinny Nice to hear you will be at the Winters re-run. If you have time, the convertor change will give you the best result. I...
G'day Propinny A bit more info might get you what you need .... Is this an Outlaw Sedan with a four link or Ladder bar rear? And you...
Hi Mike Yep, this is the box that the EGT probes connect into. I was planning to mount the box on the headers because the EGTs are hard...
Hi All I'm just getting busy fitting up a new data logger and I've made some nice EGT box brackets to mount them on the headers but how much...
