BEDNAR1320's Recent Activity

  1. BEDNAR1320 replied to the thread Dragster Pinion Angle.

    Absolutely. But all I have to do is tighten the bolts up to stop them from moving....

    Dec 11, 2018 at 6:11 PM
  2. BEDNAR1320 replied to the thread Dragster Pinion Angle.

    Well, just put the car on the ground and the engine is level, also measured the pinion CL to ground and front of the crank CL to ground...

    Dec 11, 2018 at 3:54 PM
  3. BEDNAR1320 replied to the thread Dragster Pinion Angle.

    Yup, when I setup to go 3.80's or so it seems to be pretty happy, if I try and go quicker it's not so happy and that's usually when...

    Dec 11, 2018 at 3:14 PM
  4. BEDNAR1320 liked Bob Meyer's post in the thread Dragster Pinion Angle.

    Lord knows what angle the top rail is ! Find a level surface and measure to ground. Much success can be had with the crank bolt CL, 1/2"...

    Dec 11, 2018 at 3:09 PM
  5. BEDNAR1320 liked sammy christian's post in the thread Dragster Pinion Angle.

    tighten the slips, lower the engine angle, more power-- all adds up to less bite/more wheelspeed. I think you are answering your own...

    Dec 11, 2018 at 3:08 PM
  6. BEDNAR1320 replied to the thread Dragster Pinion Angle.

    Thanks for the response, Bob. I'll put it on the ground and see what is then. On this car with rear slips right behind the cage, the...

    Dec 10, 2018 at 6:34 PM
  7. BEDNAR1320 posted a new thread.

    Dragster Pinion Angle

    I would like thoughts on what effects pinion angle has on a hard tail dragster. My 09 272" Spitzer has about 1.5° up angle relative to...

    Forum: Manton Push Rods Top Alcohol Tech Questions

    Dec 10, 2018 at 5:00 PM