Separate names with a comma.
Crank shaft rebuilders in Melbourne if you want to keep in aus, but I’d send to marine cranks in California,not that expensive to freight when...
Email sent
What heads are you running? You can tap into the rocker feed in the front of the head and run a dash 4 or 6 to each one from oil pump or rear of block
Blow air back down from the rocker feed to the cam journal as restrictor jets maybe blocked. I never use this feed anyway , what heads are you...
Is it a long shaft or short shaft, how long since last cert? Any idea on how old? Could you send some pics to jason@wtcv.com.au Thanks
Is bae doing a new threaded timesert type repair kit for the side threads on their block main caps. Seen a few stripping recently and someone...
National seals # 471795
I have a 8 5/8 browell steel can and tried fitting a trick titanium can but the large studs in the engine plate are in different locations. Is...
there is a page on facebook, keith black racing engines, Kenneth is normally very active to responding on that page and helped me a lot with the...
Garvin motorsports!! Best follow up service, advice and quality product out there!!
I wouldn't be worried about timing etc till I sorted the first gear! Going to a 2.17 in my opinion was the wrong direction to an already stout...
Ive ran that block that hard plenty of times and would agree the intermittent shut off probably caused the drama, but definitely open up those oil...
Even some photos would be appreciated of your kitted out buggies, starter mounts,jumper battery boxes etc Thx jason
