Setback plate O-ring question

Discussion in 'PSI Superchargers Tech Questions' started by BEDNAR1320, Aug 7, 2015.

  1. BEDNAR1320

    BEDNAR1320 Member

    Joined:
    Oct 8, 2008
    Messages:
    323
    Likes Received:
    21
    The top of my setback plate uses an O-ring to seal to the bottom of the blower, is there any special place I should position the ends of the O-ring. I was planning to put it at the rear center, but just don't know if it makes any difference where it is. Also should I put a small dab of silicone at the ends?

    Thanks in advance.
     
    #1
    BEDNAR1320, Aug 7, 2015
  2. Mike Canter

    Mike Canter Top Dragster
    Staff Member

    Joined:
    Mar 10, 2004
    Messages:
    4,630
    Likes Received:
    189
    It doesn't make any difference where the joint is. You can join the two ends together with superglue. I little dap of silicone sealer doesn't hurt. Some racers put a very small amount of silicone sealer all around the oring.
     
    #2
    Mike Canter, Aug 7, 2015
  3. BEDNAR1320

    BEDNAR1320 Member

    Joined:
    Oct 8, 2008
    Messages:
    323
    Likes Received:
    21
    That's what I thought.

    Thanks, Mike
     
    #3
    BEDNAR1320, Aug 7, 2015

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM