Need a couple of torque values...

Mag KB fuel head manifold to head nut and roots blower stud nut. I did a search on both, nothing.

Thanks for any help.

-Brian

 

Manifold preferably two people start in center and then work opposite corners till tight.

Blower studs starting at center working out -20#

 

Finally! Thanks for the answer. I didn't get a response so I had to wing it. Oddly, that is exactly how I did it, except I didn't have a second person for the manifold. I just stepped it up in little increments in a center-out criss-cross until it was snug. Blower felt right at 20#, so that's where I left it.

Thanks again.

-Brian