Main cap Tourqe Pattern

Discussion in 'PSI Superchargers Tech Questions' started by jonimus333, May 11, 2008.

  1. jonimus333

    jonimus333 New Member

    Joined:
    Nov 7, 2007
    Messages:
    504
    Likes Received:
    0
    KB stage 10 block. Do we torque, the studs first and then the side bolts, or should I alternate as I torque the studs. Any ideas. never did anything special befor. Just woundering what the thoughts were befor I snug these . Thanks Don
     
    #1
    jonimus333, May 11, 2008
  2. bruce mullins

    bruce mullins Top Dragster

    Joined:
    Aug 2, 2003
    Messages:
    1,002
    Likes Received:
    5
    always the studs first. if you tighten the sides first, you might not get full pull down on the cap
     
    #2
    bruce mullins, May 11, 2008
  3. lugnut

    lugnut Member

    Joined:
    Dec 3, 2006
    Messages:
    145
    Likes Received:
    0
    I was also taught that when loosening,always loosen bolts then studs. You also want to make sure that you tighten 3/8 bolts in rear main after cap is torqued, and always loosen those bolts before you loosen cap.
     
    #3
    lugnut, May 11, 2008

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM