Data Logger Help

I Getting Ready To Buy A Data Logger From Rpm I Need To Find Out A Little Info Where Is The Best Places To Put The Sensors For The Fuel System Also How Far Out Do The Egt Sensors Need To Be From The Flanges Also Where Do I Get The Driveshaft Collars And The Input Shaft Speed Sensor For A Lenco Trans. How Does That Hook Up And What Do I Need To Get For This Install Any Info Would Be A Great Help Do Donts Things That I Should Know I Know Randy Will Help Me Out We Have Spoke But Just Wanted Other Teams Input On This I Know Many Guys Have Found Out Thing That Work And Dont Work I Was Just Hoping To Save Some Headaches Thanks To All Jamie

 

Hey Jamie....
Autometer makes the driveshaft collars, but you should be able to get them from RPMperformance (I think that's who you're using???). Be VERY careful when you tighten the brass stud (magnetic pickup) for the collar, they will break in half easily. As far as the EGT's there will be instructions that come with it, but you should put the probes 1 1/2" - 1 3/4" away from where the flange and head meet and 3/8" in the hole (if you going in from the top). Double check though with the directions that he should send. I've had great luck with the system...easy to use. Not sure on the fuel sensors and input sensor...i'm going to that this year as well. Hope this helps....

Josh