Clutch help

Discussion in 'PSI Superchargers Tech Questions' started by fcsteve69, Feb 7, 2008.

  1. fcsteve69

    fcsteve69 Nostalgia FC

    Joined:
    Sep 6, 2005
    Messages:
    136
    Likes Received:
    0
    I could use some help. I have parked my AA gasser and moved to a nostalgia funny. BBC with a fresh Titan 3 disk and a 3 speed Lenco. I am clueless when it comes to the clutch. Any one local to Detroit that can point me in the right direction? I'm in Belleville.

    Thanks
    Steve Timoszyk
    ftroopwillys@comcast.net
     
    #1
  2. AnimalCrew

    AnimalCrew New Member

    Joined:
    Oct 25, 2005
    Messages:
    64
    Likes Received:
    0
    Do you have any old runs to go by. Was this car run with this clutch in it before? Do you have a data recorder with Engine, clutch and DS RPM?

    Have you made any passes yet?

    Troy.
     
    #2
  3. fcsteve69

    fcsteve69 Nostalgia FC

    Joined:
    Sep 6, 2005
    Messages:
    136
    Likes Received:
    0
    Clutch

    Troy this is a new car 0 runs. The clutch was run by a westcoaster with about the same combo. I have not been able to contact him for help. No data recorder.

    Thanks
    Steve
     
    #3
  4. hemi altered 378

    hemi altered 378 Blown Altered

    Joined:
    Jul 3, 2004
    Messages:
    864
    Likes Received:
    0
    Steve,
    if i were you i would go to this board and post your question. i presume you are running a slider clutch........lots of info available on those over there.
    http://www.classicfunnycarboard.com/ i would talk to Dave Benjamin.......he's really sharp on those. hope this helps
    Darren Russell
     
    #4
  5. fcsteve69

    fcsteve69 Nostalgia FC

    Joined:
    Sep 6, 2005
    Messages:
    136
    Likes Received:
    0
    Clutch

    Thanks Darrin. It's a pedal clutch, running alcohol. I'll post over there also.

    Thanks
    Steve
     
    #5
  6. jim phillips

    jim phillips ta/fc

    Joined:
    Apr 29, 2007
    Messages:
    1,242
    Likes Received:
    0
    put 2 1/5 turns of base and 47 grams total weight and 60*thousands air gap at the pedal that will get you started and see how much it wears off of the disc


    i may have misspoke i am not sure if the aft set up is like a crower and a bonnifontie if it does it should work
     
    #6
    Last edited: Feb 11, 2008

Share This Page