Separate names with a comma.
Diode in the circuit to the lean out from the Transbrake button. Dave
Pit Pal offers different tables even one that clips on anywhere you want. https://www.pitpal.com/tables/ I have one like this....
Mike, I guess what I should have said was after re-stripping the rotor I have to put them in the lathe and trim them to the clearance I'm shooting...
Last season I broke a rod. Pieces of the piston and other material somehow went from the crankcase to the top of the blower and back down. When...
500 CI Mopar wedge with an 871, bracket dragster. I run a Grid. I chip the Burn out to 5200 and launch to 3200-3400 depending on conditions. I...
You have pictures of my heads?? Or do you want me to post pictures? I'm looking to sell my hemi. Just not really feasible to bracket race a solid...
Now we have electronic lean outs...o_Oo_O I'm fat at idle right now, but I'm waiting to get to the track before tackling that issue.. Dave
Idle bypass is only supposed to be active when throttle is closed. Main purpose is to return excess fuel when you chop the throttle the poppet...
Got it, so as I have already done I am compensating for the leakage by adjusting the main fuel return.. I was just curious as to this leak being...
Thanks Mike. Yes I cap it when doing a leak down also. But when using it on a NA motor the main pill that is normally in the BV is a blank. Then a...
I have a Enderle Square BV on a NA injected engine. Idle check is set to 25 lbs. Throttle blades set at .010. I notice when we were leaking the...
FYI.. Talked to Glenn at TBS. Rotors are cut for nylatron or teflon. Each has a different profile. Blower case can be repaired but at the expense...
I had planned to. Just thought someone here would have some recommendations.. Thanks Mike Dave
I have an TBS 8.71 that was on my car when I broke a rod (steel). Piston and pin disintegrated and I found pieces inside blower above the rotors...
Thank You Neil. Obviously I was not aware of any of that. Much appreciated. I can build a set back plate to get it as close to centered as I can....
Picture of blower. [IMG]
Email sent Thanks
Mike, Thanks, I was under the impression it came out at a 90*. When I first installed it I was running on hat nozzles only. At the 4th pass it...
BJ, believe me boost will come out of there. I found that out when I first mounted the blower, not realizing it was open..
Thanks Bob. It's just a bracket car. It did run 4.30's until it broke a rod last month. I'm going to set it back for sure, but was curious as to...
