Separate names with a comma.
2 - 60mm tial wastegates black tops $400 each 2 - Tial 50mm blow off valves silver tops $150 each 2" LSx turbo headers with EGTs $1200 - Stefs...
I've got a fuel injected small block on M5, seeing some high EGTs at idle trying to get it figured out. Fuel is low 4's AFR and timing I have...
Small block LS style motor RCD Mag drive Jesel Belt drive with the longest Hex drive/cam bolt they offer Problem is I can't get the mag close...
Made some test hits yesterday and still sifting through the Data. A/F was 3.15:1, EGTs were 1120, 35# of boost, 18-20 degrees of timing. Plugs...
For you guys using water heads, during warmup when the water temps are 50-120 degrees are you guys using a lean out valve or pulling fuel to get...
Probably a dumb question but are there any downsides/problems with zip tieing 4 spark plug wires together in a bundle without seperators with a...
Just switched fuel from M1 to M5 and seems like M5 needs to be about 10% richer. Its a new combo and last time out the A/F was very rich at 3.3:1...
I seem to hear 50/50 on running water in the motor with methanol. Some say dont run it, its not needed. Some say run alittle water to even out...
Still learning how to setup the big cap promag44, what to make sure I am phasing it right. - I fired the motor up and on the internal mag...
What does a normal boost/timing retard curve look like on methanol? Is there a point where you just stop pulling timing out?
I got my FIE crank trigger installed today and had some issues getting it fired. I initally had the gap set at .065 and it would not fire and the...
What crank trigger sensor are you running? Right now I am running a basic MSD crank trigger sensor but think I might be picking up some noise.
I recently dynoed a small block turbo with a MSD 8 plus igntion. Got the tuneup pretty close with timing and fuel. A month later I changed over...
Is there anyone on the east coast that stocks parts and can rebuild a waterman 19gpm lil bertha fuel pump?
Ran into a wiring issue trying to get a single MSD tach adapter to run 2 outpts. I've got an MSD 8918 clip on tach adapter....
Does anyone know how the internal trigger is setup? What kind of sensor and how many pickups/triggers are on the wheel?
What kind of reliability concerns are there when running a belt drive for your cam and a front mag drive?
Where is a good place to buy 1.25" ID hose for burn down tubes? I've heard alot of guys are using layflat house but I've only found 1" and 1.5"...
Who makes a quality 15w40 or 20w50 for a methanol engine, I am leaning towards Brad Penn, anyone else to consider?
On a methanol fed either blown or turbo combination, how effective is using timing retard as a means of power management to control wheel speed....