Separate names with a comma.
New items: Racepak 8 EGT Vnet modules, 2 racepak EGT boxes, 8 probes, v-net connectors, brand new EGT bungs $925 shipped Pending sale: -...
2 - 60mm tial wastegates black tops $400 each 2 - Tial 50mm blow off valves silver tops $150 each 2" LSx turbo headers with EGTs $1200 - Stefs...
I've got a fuel injected small block on M5, seeing some high EGTs at idle trying to get it figured out. Fuel is low 4's AFR and timing I have...
Small block LS style motor RCD Mag drive Jesel Belt drive with the longest Hex drive/cam bolt they offer Problem is I can't get the mag close...
4.125" Bore, 4.250" stroke The plugs showed no ring around the threads and the mark was just above the base of where the strap attaches to the...
10.5:1, it was a gas motor we switched over to methanol. M5 fuel. Is there a tuneup that will make the most power? 3.25:1 A/F and more timing...
Made some test hits yesterday and still sifting through the Data. A/F was 3.15:1, EGTs were 1120, 35# of boost, 18-20 degrees of timing. Plugs...
For you guys using water heads, during warmup when the water temps are 50-120 degrees are you guys using a lean out valve or pulling fuel to get...
Probably a dumb question but are there any downsides/problems with zip tieing 4 spark plug wires together in a bundle without seperators with a...
Just switched fuel from M1 to M5 and seems like M5 needs to be about 10% richer. Its a new combo and last time out the A/F was very rich at 3.3:1...
I got the heads off to Chris Razor to weld up the decks. My engine builder is going to fill the block the rest of the way. Who knows how much...
This year we ran water in the block and heads. I want to fill the block and weld the deck so its just got water in the heads only. Some say dont...
I seem to hear 50/50 on running water in the motor with methanol. Some say dont run it, its not needed. Some say run alittle water to even out...
Thanks for the help. I'm not new to turbos but methanol and the mag yes.
Replied above and below... I am taking the car to the track this weekend, I know the EGTs were very hot at idle and on staging comparing it to...
Replied above...
Still learning how to setup the big cap promag44, what to make sure I am phasing it right. - I fired the motor up and on the internal mag...
Do you limit the boost to 20psi or do you keep the timing at 26.5 for all boost levels above 20psi?
What does a normal boost/timing retard curve look like on methanol? Is there a point where you just stop pulling timing out?
Ended up having to tighten up the air gap to .044 and swap the wires. John said they needed to go +-+- to work correctly. Swapping the wires...