Separate names with a comma.
If you are a casual non account with any of those guys you won't get great rates, you also need to ask for thier best super economy rate ;) as the...
Get onto Greg Kelly @ Motorsport Inovations, he posts on here fairly regularly. He is a good guy and will do you a good deal. I have a V300SD, 8...
From my Glide experience I would if money was not an issue have two identical, really good transmissions and swap them out meeting to meeting and...
Yes I did have this happen but I just put a sheet of heat blanket material in the bottom of the diaper problem solved... I agree that the in sump...
Check these ones as well, I have one - works fine. They have quite a range of sizes http://www.wolverineheater.com/ Pete
I have been using an air retard system with a Supermag as there are no electronic alternatives. Mike is correct it is hard to set up with any...
Thanks guys - Pete
When hooking up an 8973 controller can the gray tach output wire be used for the RPM signal on a V300SD? Any other tips and tricks to keep an...
Thanks everyone for the response, someone had told me that they had heard of issues but I now have the confidence to go ahead... Thanks for the...
Hello Mike... No problems, I can get a good deal on one with two boxes. Thinking about it to replace the Mallory Cheers Pete
Howdy... Does anyone know of any issues or had problems with the Pro Mag 12 with the 20 upgrade? Cheers Pete
The ETC unit I have is one of Spuds and I have his hopped up mag - I have not tried mine on a 2 step set up, as previous the problem I have is I...
There will be more than one on the market soon ... BTW sent you a PM Pete
Yes I wish I had just went with a pro mag to start with, the money I spent on having the Mallory checked and hopped up with FIE and then the rev...
I don't know about the other units but I have had no luck what so ever with the ETC. Fitted as per instructions, wanted to do much the same as...
Most of the Aussie Door Slammers (Blown Pro Mod Style) are still doing it this way - very few on a 2 step and they almost have to run a sub 6...
The sleeves on my New Century block are .004 proud of the deck. Gasket thickness will depend on your application, comp ratio and clearances. I use...
Ron... I use those plugs as well for the same reason - Big Chiefs, I have been getting them from Summit for I think 50c more where do you get...
The car has not had this blown engine in it for very long. I am following the weather but it looks like the baseline I started out with was out of...