Separate names with a comma.
+1 I bought a set of CamFX and one set didnt even have the roller shaft pinned. When I took it out to inspect the roller fell out and needles...
Cam is only 246'@0.050 with 0.580 lift, Indy alloy block, unbushed lifter bores, mostly street. Still sorting out the springs. Cam is hyd roller.
In a world where most people say "you get what you pay for" to see a set of performance lifters for $350 a set is a little of a concern ????...
Ok, its not for hard core racing but my street/strip build hemi 426 needs a set of hydraulic roller lifters. Standard hemi diameter. Who could...
If you spin a main you can fit a saddle and a new cap, thats fine. What about if the rear seal area is damaged. The crank is already 3" main...
Not much help if your not on facebook ...:(
The "proper" ray barton website had all the hemi engine parts listings and pistons etc etc. The link above is part of a car building thing with...
Tried the usual www.raybarton.com website but it never connects, tried to google it and nothing comes up ???? Ordered some parts from these guys...
The saddle should ideally be the same material as the cap. If the cap was alu and the saddle was steel when the bore of the mains is machined it...
Your right about the heads I have, Hansen Stage 5 full water jacket. The engine will be full EFI and running individual coil packs for spark,...
In regards to the 426 Hemi. Are all the valve covers for twin plug heads the same, not counting exotic heads like the BAE or TFX. Im refrerring to...
I have a KB alloy block which has wet sleeves. The sleeves seal at the base and top with a o-ring. I cant see the top leaking as its seals...
The sleeves I have are darton part number #51425-187-FH. The ones I have are a combination of new and used. Some only have light scuffing from a...
I have a bunch (11) of darton sleeves from my KB stage 10 block. The issue is they all have a large notch cut out of the top edge for intake valve...
Wow, I didnt think this would be so hard to get an answer.... Seems two possible options are Crower "Maximus Series" or CamFX. Does anyone...
I am searching for someone who makes a 1" diameter solid roller lifter that has internal oiling for the roller? CamFX , Crower , Isky ?????????
The catch is with the 1" diameter lifter size I dont think they are even available with an oiled lifter design. I checked with a few manufacturers...
I have a KB block with solid roller lifters/cam. I have heard that at prolonged idle situations the lifters/cam will fail due to insufficient...
Thats exactly what I needed to know. Much appreciated.:)
I have an early stage 10 KB block with a raised cam. I'm trying to get the gear drive sorted out to fit this block. I have a KB raised cam gear...