Separate names with a comma.
..is there any grounds wires from the heads ..to coil negative ...then back to all the electronics and battery ?
no sir, those 10's were last made 2010 ...and the coils are no longer available ... 8208 coil was discontinued in 2012
sounds like the ryflex square ring between the magnets and shaft..
lol.................
that msd 10 has not been built since 2003. over 10 years ago.....and no, no other coil will work ( the 8208 coil was last produced two years ago)..
also aeromotive parts too. http://www.dragzine.com/other-tech/counterfeit-automotive-parts-knock-it-off/
it was the harness ! he made.
seen this combo awhile back. http://www.youtube.com/watch?v=PGe5VKNlMbA maybe he could get you in the right direction.
it cannot be used as a replacement for the 8993!
THE 8998 is only for c.d. ignitions.
PRO MAG'S DIRECT NUMBER 915-856-2785 FROM 7AM TO 3:30 PM MOUNTAIN STANDARD TIME. MONDAY THRU FRIDAY ... keep in mind that we are...
I ASSURE YOU ! they do not go to 45 or 46 amps.... closing the air gap on the magnets is just going to make it "dig into the center section after...
all those specs have been checked at the factory . http://www.youtube.com/watch?v=a1lfWWTfk0c&feature=youtu.be
use a 20 amp .....p/m a daytime phone number...so we can talk about the 20amp.
dunn 417-967-0528 or paco at rcd ..530-292-3133
i agree, sounds like at some-point, the wheel contacts the pickup.. rotate the motor by hand and check it air gap on the 4 magnets .
same you some hassle, get a race pak!
are you using the tach convertor with a brown /yellow and a brown/orange stripe wire? grounds..are very important!..... i would make sure you...
depends on cranking rpm, fresh blower, weight of oil, temperature of day , ..etc.
MSD 10 has not been made or sold for over 3 years now...and there is not any replacement coil coupler available.. the newer model 10 boxes that...