Separate names with a comma.
I'M guessing the shear velocity of the air being forced in, sucks air usually accompanied by oil from the lifter valley. just as gasoline is...
Check the O rings where the head and intake mate together some guys add a little silicone to make sure they dont suck air.
Has anyone used one of these and if so could you offer some feedback. i'm thinking about using one on a nostalgia alcohol funny car. i talked to...
x 2 ditto that
You may want to send that digital 7 box in and have it checked, msd has had a bad batch of those boxes causing severe problems. But yes cycle...
I had pretty good luck with these guys. http://www.rh2way.com/contact.php
Thanks Bill, that was the first place that i originaly had it installed before moving it to the back of the block but i didn't see any effect in...
accumulator I ran the moroso 3 qt setup for years on my chevy motors but now that i'm running a hemi setup i cant figure the best way to plumb it...
Try running less toe in. bring it closer to 0. i know if i try running 1/8 toe in on my car it will rip the steering wheel out of your hand after...
I've run billet caps and factory caps, spayed and straight bolts and my thought on the chevy's is the most important thing is to have good tight...
If you have the room for it You can also run the air cyl down near the throttle pedal, i've had mine that way for 5 years now and prefer it over...
If you were only running 10 quarts that's most likely your problem. with 160lbs of oil pressure you'll run the pan dry pretty fast and the oil...
How many quarts of oil are you running? there's a chance you sucked the pan dry. the oil drains back very slowly on some of the hemis.
If your running braided hose from the tank to pump make sure to run a spring inside so the pump doesn't suck it closed. i raced with a guy years...
i ran a msd 7 for years and carried a old 6al for a spare. i actually ran my fastest time ever 7.36 in that car using the old 6al. this was in a...
I don't know how the machine shops do it but i've had good luck with using the corner of a small chisel. look real carefull and find the parting...
you may want to check that the o rings are lining up properly with the reciever grooves i usualy just spray a little fog coat of spray can primer...
Ohio crank John, i ran one in the chevy motor for 3 years and it's still in good shape.
rods I used to run Chevy motors and have also put as many as 200 runs on a set of rods. i used to run Venolia rods in my mid 7 sec chevys, but i...
some of the KB Olds blocks will have a dual bolt pattern. what you could do is screw in transfer punches into the hemi pattern and then just...