Separate names with a comma.
you have bob weight
i have Yamaha 1991 gas and i tow 2800lbs with driver no problem
Thank you for your help
I don't have flow sensor and i don't know how mutch boost .but i have egt drop to near 400.what is the best egt temps on 2 step
i look to install a lean out on transbrake its better to instal before or after barrel valve ? and i began with what size of jets ?hemi coan...
hi have hemi 3.900 stroke 14-71, 31od rev around 10000rpm ,now its time too change crankshaft ,what is better 6 or 8 counterweights
thank you all for your reply
i need parts for this offset drive .but i don't know what compagny build ,i need lower shaft ,gear,bushing in block (bae) [IMG] [IMG]
http://www.insidetopalcohol.com/showthread.php?38710-water-grans&highlight=water+grain
buy a Ultrasonic Thickness on ebay
around how many hp between 26 and 30 ,just for know if i try one run at 30 ,
i have a BAE with4.310 bore I can bore these sleeves to 4.375 bore .if possible what is best way to make this
i have 3.900 stroke 4.310 bore (456ci)14-71hh bae5 head msd 44 big dome 35lbs boost i'm run at 27 rod bering always good
how know if its k8 -k9 or k11 when you see the blower .you can explain this ,or where i can go for see (internet)
What seat pressure should I set-up my valve springs on Bae 5 with 296-500 ,victory valve. roots 35psi and 10000 rpm
i buy mine in ontario http://highforcetools.ca/index.php?dispatch=products.view&product_id=30157
around same set up 4.46 1/8th 163mph 2770lb 456 brad 3.900stroke 35lbs@9500 3speed lenco 1.90/1.48/1.0 4.88rear gear but below 1% at 1/8 you...
i have a coan super mega convertor and 3 speed lenco shift 9500rpm .convertor slip 0.05 % before shift and at the end of track i would like to...
now i have 3.900 stroke and 4.310bore but in door car 2770lbs .probably better 60foot with more stroke and bore
what is the maximum stroke i can put on bae -500 deck for keep safe rod ratio with 4.375 bore