Separate names with a comma.
Boy... this thread would drive a Pro-Stocker insane. It would outright give him a heart attack. That much oil left up top and being spun aroung...
Boost referenced power valves Power valves can be an asset when used on a blower combination if the carb has been boost referenced. When the...
Six Shooters work great and interface with the MSD 44 and control boxes. The Six Shooter is an MSD box that offers you the option of running at...
I agree with thjths. More than likely you have shook loose the fiber optic pickup. Check that the fiber optic is seated properly. You may have...
Glenn, Blown, Don, I sure was not trying to piss anybody off as really we are all more or less in the same boat. The reason I have considered...
The main differences in clearances in a boat and a car that I have seen have come more in line with cylinder bore clearances, if the block is...
I kind of like the amendment. I have always thought that a TAD and a T/D were two different beast. Considering running our A/ED single carbed...
I have a can of SERVICE PRO brake cleaner on my desk that states non-chlorinated and also states it uses no petroleum products in the propellant....
David, As Enderle, Mike and SoDak are trying to explain, your pump is way too big. A fuel pump has a "flow curve" that needs to be matched to...
Here are the NHRA Accepted Products These hoses are "spec". NHRA Accepted Vent Tubes/Hoses Updated January 19, 2010 Manufacturer Part...
Where is the best supply for the Brad Penn 70 wt? Can you purchase it by the 55 gallon drum? Thanks! Steven Smith
Greetings, I have a couple of customers considering ring grinders. Tell me a little about yours and the cost. Thanks! Steven Smith...
Jody, I just got to thinking a little more about the head change. It would be interesting to know the difference in flow of the cylinder heads...
Jody, You have not mentioned the cross sectional difference in the port size. If the port flows that much more air, then I would assume it is...
Spitzer states Bill uses his scoop. Spitzer has done a lot of wind tunnel testing through the years. www.gospitzer.com
Question on the AF/PM. Was Conway tuning the engine or Joe Monden?
I agree with several guys above. I had a customer come in with a dragster a few weeks ago w/ Quarterstick and exactly the same problem. I...
Creech, In your original question, you asked what happened when you put an A/F from the low side to the high side. This process takes place...
He is rolling into the high side at the marker just prior to staging, approx -5.6 and "0" is where he decks it at the beginning of the run.
Creech, you mis-red the graph. The engine was on the low side prior to -5.6 where you see the temp at a higher level while lean. When he put the...