Separate names with a comma.
End result... a buddy of mine had an extra switch, installed it, worked like a charm Amazing how still the timing light is, and how smooth the...
X2 for ERC in San Lorenzo, Rick is great to deal with and also is an associate sponsor for my program. If you have any questions or need fuel...
Well I'm glad I did, my crew cheif and I got the whole job done from running engine, broke down, back to running engine in 2.5 hrs....
Called Dave, he said crank speed is more than likely the issue, suggested removing spark plugs and or blower belt to test it out. The 5 degrees...
ok... checked phasing, everything OK spark plug to coil, got spark on mag and thru 7730 w/ mag spark plug on coil w/ trigger to coil, no dice...
Mike, so if I hook up a spark plug to the coil... ground it, and turn over the motor with A) the Mag hooked up normally, the plug should spark....
Gotcha Mike, thanks for all the input... I think we're all on the same page now. Engine runs Great on the mag alone, just won't run at all on the...
I'm stil having trouble understanding this 180 off deal. If there are 4 magnets on the wheel, every 90* If I set the crank wheel to 32*...
Now one thing I didn't do... (just spoke to MSD again) is when I set the crank back at 32* I didn't pull the cap or spark plug to make sure it was...
Mike, I have done #2, When I drop my distributors I always set the crank at the desired timing (32* in this case) then drop the distributor...
It is an onboard starter, SBC Mike, can you please explain rotor phasing? it's a ProMag 12lt
I never ran a crank trigger before and just put a Lehey trigger on but the motor won't fire. I'm running a 16v battery setup, logger shows 17v on...
Pro Torque
Running out of time before a race next week and I don't think I'll be able to get everything done so I can run some heat thru this thing and...
I use a racepak V300SD with all the typical sensors for fuel, pressures, flow, ect.. no EGTs yet, but one day when I can afford them. I can tell...
mine just showed up today! just have to install it... software is gonna be a little tough to get the hang of coming off the 8973 but as long as...
I am at 4.170 right now and run water, had an issue with it last year where water was pushing out of #2 plug hole, but when I got the motor apart...
If you wanna go high 4's in the 1/8 on a TT5, buy my motor, it will definately get you there... it's for sale turn key, hat to pan, fuel,...
I've got an all out competetion SBC 410" with 23* heads, only I'm running a 10-71 HH blower. Have been 5.10/144 in the 1/8 at 3100lbs on a true...
I spoke to Rick Santos regarding this and he advised against it just because of the siamese cylinders, said even with solid heads people were...