Separate names with a comma.
What is the opinion of the guys who know about starting the motor when its cold? Whats the coldest you would start the motor without pre-heating...
I have asked about this trans before on here, now I am looking to see if anyone has parts for or knows anyone who might have parts for one. I am...
In a blown alcohol door car what spec gloves do you need to have? I have a 3.3/15 suit but only 3.3/5 gloves. Should we be using 3.3/15 gloves and...
Trying to install a block starter from srcatch. Motor is a KB Hemi cast 426 block with Dan Olsen oil pan has kick out on passenger side so...
I have a 20 year old KB 426 Blown Alcohol with a Donavan gear drive that we are trying to degree the cam timing in on. I have spoken with...
What do you do when your timing ring is smaller then the bottom pulley? My hub has the timing ring attached to it so I assume I change that...
We have a stage v Keith Black block with brad 1 heads ( the fuel heads) with a 1/2" lowered deck.I have been told this was a Top Alcohol motor.It...
I need a neutral safety switch for a reverser lever on a C-S1 lenco, it has a neutral installed with Lenco's shifter.
What is everyones opinion on best type of pneumatic valve spring compressor. I am looking at buying a Snap On just wanted to know what else is...
Any of you guys familiar with running the Torque-Link on a Lenco. I have one and am planning on running it I just dont know anyone who has and I...
Ok this weekend I picked up an old Torque -Link unit. Anyone have any experience with them? Are they any good does the company still...
I just aquired a CS1 Lenco with a 3 disc clutch. I want to go to a automatic conversion, Lenco drive , or Bruno.But before I do I would really...
I need to know what brand of leak down gauge you guys prefer. I have the simplest one that summit sells but its not as accurate as I would like,...
I am changing the rod bearings in our 392 and just wanted everyones opinion on the prefered bearing to be using for a blown alcohol motor....