Separate names with a comma.
When wiring the electric solenoid lean out jet to the clutch pedal switch to bleed fuel while going wide open staging on the 2 step the jet will...
Curious if anyone with a blown hemi has tried using Amsoil? They have a synthetic 60wt that has all the hard chemicals like phosphorus and zinc.
I have heard different ideas and thoughts on picking the starting point of a run on the computer. What is everybody doing here and why. Driveline...
Does the computer pick up the very initial g force signal at the same time or point in the run no matter what position the computer is located in...
Hey Will, I posted in tech forum about loss of oil pressure on my wet sump BAE. After some discussion I am wondering if my #16 hose from pan to...
It doesn't recover when I lift but one time after I lifted I stepped on it again briefly and the pressure began to climb with rpm.
That is a good thought. I run out of pressure at 4.2 seconds in run whether I have 13 or 18 quarts of oil. I have ran with restrictors in the...
I just measured to confirm the holes are .050.....restrictors are not in block they are screwed in the bottom of the rocker stand.
I have not measured the restrictors. They are Manton stands and rockers and I would guess the hole is approximately .050
Having troubles making it to the end with oil pressure. I have a BAE with funny car Williams pan and system 1 wet sump pump with 1.8 gears. #16...
Funny car BAE set up. Putting together dry sump oil system and want to know whose pump everyone likes best and why. Thanks for the input
I am putting together a BAE with a wet sump funny car pan. I have heard from previous posts I will need to run approximately 13 quarts of oil to...
Is there a performance advantage to using a 2 step rev limiter while staging a blown clutch car or are they used mainly for consistancy for driver...
Does anyone have feedback on performance gains from using an injector spacer like one from DMPE on a roots blower set up?
I am building a short stroke small inch hemi in a short deck block. Does rod stroke ratio matter as much in a blown alcohol motor as it does in a...
Hello Greg, Call me if you can I had some questions about racing at Sacramento Pro 7.0 Thanks Todd 503-577-1946
I have a barrel of alcohol that is a little over a year old and has not been stored very well. The seal was in tact and the specific gravity of...
glide lenco 1.036 1.069 60ft 2.849 2.865 330ft 4.377 4.363 1/8...
Just a quick comparison if anyone is interested. I ran back to back weekends with similar air and track conditions. Blown alky small block chevy...
I agree with alkydrag. You need a flowed system and read your plugs. With that being said I run a small block with 23 lbs of boost and the center...