Separate names with a comma.
Only at 20 over Jason. Thought this was gunna be an issue for Spud............ Maybe not
Ok thanks. So, after looking at the belt cross section dimensions it would seem a GT belt should only go on a GT pulley, and same with HTD? So to...
So wats the difference between 14mm and 14mm gt pulleys and belts? I see some sites offering Kevlar belts in 14mm and Carbon in 14mmGT.
Pushrod length is also important. Make sure the oil feed in the adjuster lines up with the supply hole in the rocker. Also check that shaft is in...
Any one know why they went to so much trouble to get oil back down in the rear of these blocks? They have galleries that put it into the very rear...
start up a switch on the blower solves that. who would ever rely on a driver?
6 shooter To be clear........ A 2 in the second hole gives 27 - 2 = 25
So, if you have say 27 degrees on the mag with a zero chip in the first hole, then take the zero out and replace it with a 3 chip I can see on the...
Thanks one and all - seems a lot of personal choice as well as some logic. Interesting that no-one has said 'use whatever is in the motor' as I...
So heres one a them 'everybody knows the answer question' - wat type of oil goes in a regular ol 3 speed lenco? Is there really only one answer,...
Thanks. We are talkin about 'fat' heads arn't we? Any issues with the joint in the angle drive?
Does an angle drive let the mag clear heads/rocker covers ok. I think I am a little tight for room for an offset deal, but will make it fit if its...
Should have mentioned - talking clip on 36v starter with 48 up it and spinup before the butterflys get opened to clear anything. Generally don't...
We do it a little different......... have a switch in the car and one on the blower. One guy can start it. He turns the motor with the fuel on and...
Thanks, luckily mine works good, just wanted a small change... I guess the GFC got em! Mike
Do we know if these guys have dropped off the planet? No e-mails, phone disconnected?????? Any ideas........... Mike
The obvious thing to do, he is a busy man and I did not want to bother him with lame questions. Can call him if no-one really knows the answer....
Whats the difference between 88's and B2's in a Brook Rod? Thanks
Thanks Lowcountry, I actually meant the Racedata Inc I100, but maybe thats what you thought anyway. Any problems with the setup? Any one else? Mike
Any one using the Racedata inc i1500 or know of their success?