Separate names with a comma.
several motors available veney alcohol head or veney fuel complete turn key or partial .several ssi blowers 8-71 and 14-71 also complete 3 engine...
splined snouts for alky is great sodak I have been using psi splines for a few seasons now have them in all big blower motors on tractors,they...
cap walk I used one on my 572 bowtie block in the twd but could only say it might have helped some ... still moved around .. alota blower for the...
agree with tol had v mains lower look like this a few times on several different blocks kbs,most recently last week ,main cap was broke (alu...
brad penn we are dealers for brad penn in central indiana, give us a call feiss motorsports 513-460- 1928 thanks,Rick
oil leak had this problem ,money shot , has your kb been line bored/honed just prior? one of ours was by a different shop ,result was seal was...
ssi we have been using many of the ssi blowers with f rotors for years although 120 degree, there curent stuff is among the very best.Rich and TJ...
anybody trying iskys new bushing (non needle bearing) lifters? I got some to try,not ran yet.otherwise currently running crower maximus ,just...
no 20 bearing we just damaged one past .10 clean up .we are having it chromed back to standard better make sure there is no cracks first.probably...
oil 20 oz of oil is right for littlefield hhelix . Having different oil than in motor I like because not only does it burn ,like mentioned, you...
pre lube I will coment on this one ,we have run this setup with veney fuel heads for some time now. I do not prelube every run this is on...
Lb20 I agree for the money there great ,the LB20 is the latest avaliable it has an open pocket on top front of rotors . really you can use it...
same here BAU 14-71 60 over nothing would hold , hurt rotors. wish could find somthing for belt chips and nuts ,bolts etc.
crower performance pros 906-639-7767 or darren at rursch specialties 309-795-1502
valves thanks guys, unless it was all thumbs up I wont chance it ither
rev mallory Here try Hank @ etcrevlimiters.com best thing Ive found for mallory ,consistant rev control and more .( No ground out) psi ,auto...
Has anyone had any luck with staighting titanium valves? not from heat but piston contact, valves were new otherwise sure. just for spare heads ....
top lube or not along this thought I have used lubes ,alky fuel (colored ) thought it was to much at times (mix ratio) and made pistons and plugs...
2700 bob hemi b2 brooks 40 pulls and out what about heat ,say pulloffs play a role in rod life?? thoughts ??or does the rod only get so hot?
boost thats right about where our fresh ssi 8-71 and late stye littlefields will run at45% maybe30 @8200 different engine though. my experience...