Separate names with a comma.
1800-2000 Lbs Lars
What is the best to use in a Pro Comp Altered (900-1000 Lbs, 2000+ hp), 2 or 3 disk clutch. We has the option(parts) to run either and heard that...
We are in need of spare parts for lenco CS-1 We tied to get in touch with Lenco by e-mail and phone, but we where put in que and calling from...
What material should I use for a sadle in a KB Olds alublock, Iron or Auminium?
Batteries We use two Odyssey PC545 to our blown KB olds, MAG 44. Only thing is that you need the propper charger (Puls charging) www.centry.se...
Car info: 2400 lb doorcar (ex.pro stock, upgraded for pro mod) 3 spd Lenco, Mark Williams modular 9.5" 4.33:1 Info on the clutch setup: 6...
we have been running a RAM 10" 6 leverer (Chevy FW) on a Gas blown chevy (~1400hp) in the past. Upgraded to blown alky KB Olds 526 (~2300 hp). We...
Is there any advantage to use lower pressure on the exhaust spring than intake due to blower pressure? May have been done fore saving treads in...
What heads fits on a KB Olds solid block? Would have a set for our spare engine. //Lars
How deep do a clutch can has to for a 3 disk RAMclutch. Do I need deeper than 7.5"? Lars
Just starded Started the engine an hour ago, Set timing for 27* and it started fine going to set ingition on 29 before 1st launch. //Lars
We are our own engine guys :-) We bougt this engine in feb. and has restored the most during the season, now its only one event left (next...
What would be a good starting point for timing on a KB Olds 526. AJPE heads, ~11:1, Littlefield K11 @20%, Carbon hat, Clutch, 4 speed lenco,...
We got a KB Olds 526, Littlefield 14:71@20%, AJPE fuel heads. Going to run NGK r6061-10/11. I have been reading Mike Canters exelent 101 on plug...
Overseas Yes I'm in Europe, and searching for the parts for changing rotation on MAG 44. (CCW to CW) //Lars
Searching for e-mail to REEHL Equipment //Lars Logren lars@logren.se
Where can I buy the parts for changing rotation from CCW to CW? //Lars
steel rods ? We had an order at Brooks that hasn´t been delivered. Can we use a steel rod instead, KB Olds 526, K11, AJPE Heads. Is this to...
Is there any advantage to coat the pistons on a KB Olds, 14:71 @ 20% Does the thermal coating protect the thin material by the valve pocket ?...
Is there any opinions regarding different jetting in the hat (smaller to the rear), I'm tinking of it must mix when it goes thru the blower. And...
