Separate names with a comma.
Switching from a 5 stage dry sump system to a bolt on the block style dry sump pump. i am switching because of the mass of lines needed and i am...
i do a lot of block repair i have seen top fuel blocks that are plus .002 to .004 over on main bore and dont have bearing spinning issues
Has anyone used these i have a 481X looking for lifters 904 dia Crower no longer make them morel has body's no tie bars Cranes are junk don't...
I have used bronze floaters with great results.You have to grind them wet.even after 5 runs it takes .002 to .003 a side to get flat.They don't...
I ran blown SBC for a long time .My weak link with a iron block was the main caps would walk and transfer material.The bearings looked perfect you...
I have few several like that !!! The crack has to be 100% ground out to a v on both sides Also needs to be welded with an inverter style machine a...
He had a brodix block brodix -12 water heads think they ran water thru then into a small tank crower ultra' light forged crank
I had a 362ci sbc LF 6-71 made 25 psi 30 OD its was maxed out
What's everyone doing in a pro mod type set up. Hot track more air ? cold less air ? trying to settle an argument lol F/C guys chime in to
I started wet cutting my clutch dicks a few years ago to keep dust down in the clutch room I blow them off real good and I have not seen any...
I had one on a SBC only bearing you cant check is the rear main
From what I have been told run 30 or 85 plus anything in the middle is very unhappy and hurts parts
We switched to the BME rod with the bolt that goes to 125 FT LBS dropped pan after one run then every 2 and the torque stayed put .motor has 25...
I work on the HPL oil NHRA pro mod car .They have an awesome line of motor oils auto transmission oils and gear oils. They formulate and mix...
I talked to a top fuel team owner he said they stopped using them because on the spare motors that were stored a month or more they had issues.so...
Save yourself a ton on money and tail chasing .Get hooked up with Will hanna,Mike @ rage ,Randy Anderson,ETC and get your fuel system set up and...
Thanks for the info glad its not us have the re torqing issues lol crazy that you have to do that .I remember the R&R rod issue think the rod...
We have had some bolt failers with the 90 ft and 120 ft lb bolts .Torque wrenches check good .pan gets dropped after one run and re torqued then...
Santos ran one on his blown SBC TAD
working on a car with hemi with a chevy /hemi mid plate .Whats the best starter location will have a .500 thick mid plate . Any drawing on block...