Separate names with a comma.
Thank you all for responding I appreciate the help and knowledge and I run on alot of slippery tracks so w/ the help I recieved and the testing...
So I'm not crazy thinking that the smaller cube motor should be more efficient than the larger, I was planning on putting a shorter stroke in my...
I have had to different motors in my altered this year a 4.25 stroke 496 and a 3.75 stroke 427 w/ the same heads and cam/blower etc and much to my...
Thank you all for the help and ideas I'm gonna give both the support and a windage a shot.
It's a 496 bbc 4.25 stroke 14-71 hh
I had fresh line bore new mains and new crank 6 passes in and it happened I even turned it way down and lowered shift points don't know what else...
I don't run a crank support and I have been having main bearing issues only on the center mains front and rear are good? Should I buy...
Thank you to all w/ opinions I do appreciate any type. I'm just lookin for a little change get board kinda easy, and no problem Bob I know where...
I'm not really trying to make up for any power loss turning the blower down I just figured it was a good idea, I just want to try it out for the...
I plan on useing a small percentage of Nitro or trying it but my BBC/1471hh is a little high in the compression area about 11:1 How far can I go %...
My 496 brody headed bbc 14 HH 50% over 9500rpm. 11:1 that area seems to work well give it lots of fuel like they said.
I took my limiter chip out it was 9000 rpm and no more blown burst plate. Thank god it took me long enough, thank's for all the ideas really...
The valve springs are good I run a distributor 32 deg timing.No no boost gauge or anything.Can't test again till next week.
I'm blowing burst plates at about 8 or 900 foot mark plugs look good not burnin anything up rev limiter is at 9000rpm can't see my tach and no...
