Separate names with a comma.
Evening all Attached are some unusual bearing marks-anyone seen similar? The following is the set up: Aspirated BBC endurance engine .0035 main...
In my limited experience most blowers move air relative to eng rpm. When the blower gets to a rpm point were its efficiency falls off the boost...
Whats your rpm limiter set at and are you sure that you arent losing a cylinder or spark varition? That will your boost slightly.
you have some photos of the damaged rod and bolts, did all 8 rods fall apart?
Run a small blower depending on fuel. 900 hp is still hard to make depending on heads.
Marathon boat BBC gas engine and SBC turbo drag gas. One car is for my daughter 93 TA radial and the other is my 69 Camaro Pro Mod. What about...
No I havent done it yet. Its one of those jobs you hold off till there is nothing to do in the middle of winter. I still have a couple of engines...
Sorry I dont have any at the moment. Im tuning a car in a month or so that I did the modification on so will grab some photos then.
Probably due to having more lube coming up through the pushrods. I have found up to .750 cam on the street engines dont need constant checking (if...
you are less likley to need to adjust between rounds with roller lifters than a flat tappet. Go a little easier on the lift with a roller and you...
what sort of ignition and how much timing. Assuming you have a blower what size and overdrive?
Whos having trouble getting them? I have been told its a billet blank shortage due to: Ukrain issue Companies brought and sold Which company is...
What type of oil and pressure you are running
thats the plan
Thanks for the questions: Bearing is a coated Clevite. new billet crank. Winberg. Both sides of the bearing (front and rear) upper and lower have...
Morning, this combination is in a marathon jet boat. Steel flywheel then a splined drive shaft to a jet unit. The shaft slides freely. No...
Who has seen a thrust bearing delaminate like this before. .008 clearance. Marks both sides upper and lower. Clevite coated[ATTACH]
I am contemplating replacnig NOS with a Nitro system as the cost of NOS is stupid expensive downunder. Running a carb.
In a NA application has anyone tried seperate nitro injection or in other wards using similar to NOS?
Dumb question. What happens if you inject a small amount of nitro through seperate nozzles along side a alcohol or gas system instead of mixing...