Separate names with a comma.
I've been thinking about upgrading to a MSD 44 Pro Mag with crank trigger. I'm currently running a Mallory Super Mag 4 with a Tilton Super...
Anybody use a CSR aluminum flexplate for blown alchy applications? I have a Reactor flexplate now and had like 8 starts on the engine and it...
Where is the best place to get a deal on the connectors you use to hook the battery to the aircraft starter?
Last week I had my super mag III upgraded to a IV and now my tach reads higher than it should. At idle it is off 1000 rpm and goes off even more...
I have been running Clevite 77 H bearings in my steel rod, blown big block chevy since I built it (low 4.20's in the eighth, altered) . I ordered...
quick question. What are you guys gapping your rings at per inch of bore. Hellfire top ring and cast second ring Blown Alchol BBC. Arias wants...
I just tore my motor down and found the pistons had scuffed the cyl walls pretty bad and I am taking it to the machine shop to have it honed if...
Who makes a tool to make sure my motor is sitting inline with the rear end. I would prefer some kind of lazer. Motor is BBC, funny car chassis....
What thickness are most of you guys running for your wrist pin? I was running .200 and was told for more boost and rpm to get .250. What do you...
I'm getting ready to cycle out my lifters and came across the new Isky roller lifters that use bushings and do not use needle bearings. Should I...
While I tear my motor down and go through it, I was wondering what your guys opinon of gapless rings on the 2nd groove is. Is it a waste of time...
Does anyone know of a company making a 360 degree belhousing for a Reid Powerglide case, similar to a clutch can. My motor backfired and ripped...
Anybody used the Defnder head and neck support? I run a fairly close quartered funny car cage in my altered and everytime I try to get out I get...
Has anyone ever tried using the Pioneer mag drive with the Donovan cover and a blower. I bought one and it looks like more trouble than it's...
Had my heads remachined and need to have new wire for O-rings. Where do you buy the wire. Thanks, Adam
Who would be the best cam manufacturer or person to have grind me a cam for a blown alcy BBC with glide. My car is almost running the numbers it...
Can't figure out what's wrong: PLEASE HELP I have a blown BBC in an altered and recently burned up a couple pistons. After that ordeal I put in...